I followed your instructions about taking an eraser to the ‘mother’ and voila! I would greatly appreciate any recommendations. If you can, try entering your BIOS settings menu as soon as your computer starts. On top of that a message appears on the monitor to check all cable connections.

Unscrew only the screws at the back, which are located on the very outer rim. Report wadd 11Posts Wednesday February 18, 2009Registration date March 4, 2009 Last seen – Feb 19, 2009 at 12:19 PM I am hoping you can help me. Report sruman 5Posts Wednesday January 14, 2009Registration date January 31, 2009 Last seen – Jan 15, 2009 at 05:08 PM okay. This morning the CPU was frozen & when I restarted it, this is where I am at. More Bonuses

Computer Won't Boot Windows 10

Just a thought. When we were finished, the system shut down normally – and restarted and shutdown earlier this morning without any issues. I had it running but after installing .net framework 2 and the latest xna framework as well as DirectX 9 redistrubutable for older games I get this grey screen That I To restore your computer’s operating system and software to the original factory settings, refer to Dell Knowledge Base article, “Reset or reinstall Windows 10 on a Dell computer” Back to Top

Take your windows CD and reinstall everything, remember to format the hard disk completely. Back to Top Step 2: Run a Computer Diagnostic If you are unable to boot the system to access the Dell Online Diagnostics, use the Dell Pre-boot System Diagnostics. I believe this will not cost you much. Computer Not Powering On If the PC itself is not switching on, check to make sure your monitor cable is securely connected at both ends and plugged into the correct graphics port.

Maybe the case was not in your article.

October 23, 2013 Naman Sood Try reinstalling Windows.

August 17, 2015 Matthew Norvell I restarted the computer after installing Windows 10 and Computer Won't Boot Windows 7 You may or may not see the Windows splash screen before the blue screen appears.This kind of error is called a STOP error but is more commonly referred to as a I tried your steps and got it working. What does FL stand for?

Our next step will be to re-connect the printers – however, now we will only turn them on after windows has started and will turn them off before shutdown. Pc Wont Boot To Bios If you hear this then your motherboard is fine. I had it running but after installing .net framework 2 and the latest xna framework as well as DirectX 9 redistrubutable for older games I get this grey screen That I It doesnt say check signal, unless I unplugg it.

Computer Won't Boot Windows 7

Open up the case, and try to read the model number from the motherboard. 2. Then place it back into the memory slot. Computer Won't Boot Windows 10 Download a free program called Aida32. Laptop Won't Boot If the recovery environment won’t load or doesn’t see your hard drive, you likely have a hardware problem.

For example, malware or a buggy driver may be loading at boot and causing the crash, or your computer’s hardware may be malfunctioning. I took off the cpu cooler and felt the chip for many seconds but it didn’t heat up. If it’s a desktop PC, ensure the power switch on the back of its case — on the power supply — is set to the On position. I know the hard drive is working because I just took it out of another computer and it was working fine. Computer Won't Boot Up Black Screen

Replacing a laptop screen is possible, but difficult, and screens can also be costly. Despite of all these I continue to have the same problem meaning that I installed everything in the new motherboard but I got the same: the fans were on, the power Restart one time more, I reach the bios and the it goes black again. Power Supply fine Processor works fine.

If this doesn’t help at all, you may want to reinstall Windows or perform a Refresh or Reset on Windows 8. Computer Won't Boot To Bios If you have one, the Windows DVD can be used, but otherwise you can download (using another computer – obviously) a rescue disc image and either burn it to a CD It is usually housed inside its own little holster, with a lever on one end.

I press the CAPS and Num Lock keys and no light from my keyboard; could that be a motherboard problem?

Ensure that all your power leads are connected properly. 3 Wait at least 10 seconds. He didn’t like that at all – and suggested I plug the computer directly into the wall, until such time as I can go out and buy a higher-grade surge protector, Report Agk- Apr 18, 2009 at 08:53 AM Hi Thanks.. My Laptop Wont Start Up Just A Black Screen Is there any way I can determine if it is definitely the MB, or did a wire come loose during shipping?

Remember not to leave it ON for more than 5 secs. Go under Boot Settings/ (for some models you need to go to Advanced Options to find Boot Settings) Make sure that the first boot device is your H.D.D. Answer this question Flag as… Also the Two Jumpers to clear out Bios…My board has just pins, no jumpers at all.

My PC won’t boot: Check the power supply Laptops This is one of the most common problems. Video Warnings As with any device that plugs into wall current, if during testing you smell ozone or burnt plastic, or hear a “popping” or arcing noise, unplug the device immediately.

PC Won’t Boot.